Response: The top coat is Ranger brand Ultra-thick embossing enamel otherwise called UTEE for short. Those ATCs have two layers on them. It is a clear embossing enamel, a very fun product with lots of uses. You can read more about it on the Ranger website as well as doing searches for UTEE. You can make jewelry and charms with it as well as stamp into it when it is hot and all kinds of other things, too.

Response: Oh, too funny that you both asked the same question! The top coat is Ranger brand Ultra-thick embossing enamel otherwise called UTEE for short. Those ATCs have two layers on them. It is a clear embossing enamel, a very fun product with lots of uses. You can read more about it on the Ranger website as well as doing searches for UTEE. You can make jewelry and charms with it as well as stamp into it when it is hot and all kinds of other things, too.

Response: Thanks for the compliment. To be honest I didn't make the holder, another swapper sent it to me and I decided to re-use it to send to you rather than to throw it in the trash. :)

Response: Yes, the lady face is a hand carved rubber stamp that I designed and made myself. THanks for the compliments.

Response: It is aluminum foil tape intended for use on heating and air conditioning ducts, purchased at the local big home improvement store. The only size that was big enough for the full face of an ATC they had there was thicker and intended for outdoor use. I blogged more about this on this blog entry of mine. http://christinemmatcs.blogspot.com/2007/05/tried-using-metal-tape.html I am only starting to experiment with it. I usually use India Ink (black) on it then wipe it off to leave a black inlay. You can also try acrylic black paint. I also intend to try alcohol inks on the metal tape. I used a $3 embossing took from the craft store to make the impressions with. You can draw or write freehand. I have also put a magazine page on top then traced the paper and the impression comes out below on the tape. You can use stencils also. Or put a rubber stamped image on the metal tape then trace over the design with the embossing tool. Have fun!

Response: These were mailed out the day after the swap partners were assigned, back on April 1 and must be lost in the mail. These were sent from USA to USA. I will make new ATCs to replace them but this was not my fault.